Sq.4 Mk1 (Series B, suffix X) Cylinder block dimension?

Singles, twins and fours.
User avatar
john.bebb
Posts: 78
Joined: Mon Sep 02, 2013 1:29 pm
Contact:

Sq.4 Mk1 (Series B, suffix X) Cylinder block dimension?

Postby john.bebb » Thu Oct 11, 2018 7:51 pm

It is time to resurrect my 1949 Square for the nth time (but properly, this time!)…
… new bearings throughout, new rods, liners, pistons etc…

I do like John Witing's comment to Gui Dovey posts; -

"Gui.......you have misunderstood the instructions that come with a Sq4.........its money that you throw in the bottomless hole.....not the bike."

The engine cylinder block (& head) have doubtless been skimmed a fair few times.

I would like to know the ORIGINAL dimension of the block height; - i.e. base to crankcase mating surface to block to head mating surface.

Such will enable me to procure a base gasket spacer and possibly also equivalent spacers for the tappet guide blocks.

Yes, I know I could derive the requirement by a dry-fit and measure the piston protrusion…
but such becomes considerably time consuming…

So please; - (perhaps Bruce Longman(?)) or other with access to serious technical data,
can anyone supply such information? Thank you.

John

User avatar
paul.jameson
Holder of a Golden Anorak
Holder of a Golden Anorak
Posts: 1419
Joined: Wed Oct 12, 2011 3:04 pm
Location: Herefordshire
Contact:

Re: Sq.4 Mk1 (Series B, suffix X) Cylinder block dimension?

Postby paul.jameson » Mon Oct 15, 2018 8:12 pm

4.435 to 4.440 ins is specified for the MK II. I don't have a dimension for any other model.
Paul Jameson
36 4G, 37 VH, 53 ex ISDT KHA (project), 54 KH(A), Healey 1000/4 (project)
Former Machine Registrar & Archivist, General Secretary and Single Spares Organiser.


Return to “Four stroke”

Who is online

Users browsing this forum: No registered users and 1 guest