JohnnyBeckett wrote:hi, the spring fits on the two ears that stick out on the sliding member put the sprocket on the crankshaft first then fit the sliding member and then the spring on the outside of the sliding member on to the two ears with the cup washer that you have in your hand and fit the nuts and tab washer
will_curry wrote:I measured a new spring I got from Single Spares a while ago:
OD - 2.055" This is an easy (1/16" +) fit in the spring cup
ID: - 1.55" This is snug on the sliding member
The wire is 1/4" and the overall uncompressed length is 1"13/16.
Users browsing this forum: No registered users and 17 guests