Nuts for Watsonian Sidecars

Bikes or not. Whatever
Pete.Silson
Holder of a Nylon Anorak
Holder of a Nylon Anorak
Posts: 111
Joined: Fri Sep 16, 2016 11:31 am
Location: Wanborough, Wiltshire, UK
Contact:

Nuts for Watsonian Sidecars

Postby Pete.Silson » Mon Feb 18, 2019 3:42 pm

Does anybody know where I can source some 3/4" x 20 tpi nuts for a 1950's Watsonian sidecar? I assume they are either BSCy or UNEF. Zinc plated would be fine but ideally I would like Nyloc or similar for the wheel axle nuts.

Pete

User avatar
dave.owen
Holder of a Golden Anorak
Holder of a Golden Anorak
Posts: 1190
Joined: Wed Mar 23, 2011 10:05 pm
Location: swindon
Contact:

Re: Nuts for Watsonian Sidecars

Postby dave.owen » Mon Feb 18, 2019 4:01 pm

AOMCC Treasurer

User avatar
dave.owen
Holder of a Golden Anorak
Holder of a Golden Anorak
Posts: 1190
Joined: Wed Mar 23, 2011 10:05 pm
Location: swindon
Contact:

Re: Nuts for Watsonian Sidecars

Postby dave.owen » Mon Feb 18, 2019 4:26 pm

or go direct

dave

Watsonian Sidecars
The Watsonian Motorcycle and Sidecar Co' - based in the Cotswolds.
01386576202
Unit 72, Northwick Business Centre
Blockley
Nr Moreton-in-Marsh
Gloucestershire
GL56 9RF
AOMCC Treasurer

David Smith
Posts: 11
Joined: Sat Feb 04, 2017 9:08 pm
Contact:

Re: Nuts for Watsonian Sidecars

Postby David Smith » Sat Apr 06, 2019 9:38 am

I drilled the hub and put in car type drive in wheel studs on my Mona as the bolts were all a very loose fit. I machined the hub as the run out of the castings to the datums was enormous!


Return to “Main Chat Forum”

Who is online

Users browsing this forum: No registered users and 11 guests