Page 1 of 1

Nuts for Watsonian Sidecars

Posted: Mon Feb 18, 2019 3:42 pm
by Pete.Silson
Does anybody know where I can source some 3/4" x 20 tpi nuts for a 1950's Watsonian sidecar? I assume they are either BSCy or UNEF. Zinc plated would be fine but ideally I would like Nyloc or similar for the wheel axle nuts.

Pete

Re: Nuts for Watsonian Sidecars

Posted: Mon Feb 18, 2019 4:01 pm
by dave.owen

Re: Nuts for Watsonian Sidecars

Posted: Mon Feb 18, 2019 4:26 pm
by dave.owen
or go direct

dave

Watsonian Sidecars
The Watsonian Motorcycle and Sidecar Co' - based in the Cotswolds.
01386576202
Unit 72, Northwick Business Centre
Blockley
Nr Moreton-in-Marsh
Gloucestershire
GL56 9RF

Re: Nuts for Watsonian Sidecars

Posted: Sat Apr 06, 2019 9:38 am
by David Smith
I drilled the hub and put in car type drive in wheel studs on my Mona as the bolts were all a very loose fit. I machined the hub as the run out of the castings to the datums was enormous!