brake light wiring

General electrical problems
JohnnyBeckett
Holder of a Silver Anorak
Holder of a Silver Anorak
Posts: 985
Joined: Sat Jul 07, 2018 5:39 pm
Contact:

Re: brake light wiring

Postby JohnnyBeckett » Fri May 01, 2020 7:56 pm

HI Simon i am waiting to get someone to take a picture for me and post it up for me i can just about do a Tex's if i was not in lock down it would be done but i am old school and not in to hi Tex i am a spanner man :? :? :) :)

JohnnyBeckett
Holder of a Silver Anorak
Holder of a Silver Anorak
Posts: 985
Joined: Sat Jul 07, 2018 5:39 pm
Contact:

Re: brake light wiring

Postby JohnnyBeckett » Sun May 10, 2020 2:12 pm

HI All,

Here are the pictures of my brake light switch on my NH 350 I954, could someone let me know the best way to run the wiring?

Bike 8.jpg

Bike 7.jpg

Bike 6.jpg

Bike 5.jpg

Bike 2.jpg

Mick D
Holder of a Waxed Cotton Anorak
Holder of a Waxed Cotton Anorak
Posts: 310
Joined: Tue Nov 27, 2018 2:49 pm
Contact:

Re: brake light wiring

Postby Mick D » Sun May 10, 2020 5:46 pm

Hi

Along the inside of the footrest tube, up the frame down tube, through the grommet in the rear mudguard clip to the mudguard and out to the stop light. You'll need to split the loom at the down tube to pick up a power feed.

Thin cable ties will hold the loom on the inside of the footrest tube and will not be obvious.

Regards Mick

JohnnyBeckett
Holder of a Silver Anorak
Holder of a Silver Anorak
Posts: 985
Joined: Sat Jul 07, 2018 5:39 pm
Contact:

Re: brake light wiring

Postby JohnnyBeckett » Sun May 10, 2020 6:15 pm

HI Mick inside the footrest tube looks very close to the swinging arm unless i can get very thin 2 core cable and try it but the old 2 core cable that was on the bike was to thick to go behind the foot tube it would be good if i can see some photos of how it is fitted :?: :?


Return to “Electrics”

Who is online

Users browsing this forum: No registered users and 1 guest