Page 2 of 2

Re: brake light wiring

Posted: Fri May 01, 2020 7:56 pm
by JohnnyBeckett
HI Simon i am waiting to get someone to take a picture for me and post it up for me i can just about do a Tex's if i was not in lock down it would be done but i am old school and not in to hi Tex i am a spanner man :? :? :) :)

Re: brake light wiring

Posted: Sun May 10, 2020 2:12 pm
by JohnnyBeckett
HI All,

Here are the pictures of my brake light switch on my NH 350 I954, could someone let me know the best way to run the wiring?

Bike 8.jpg

Bike 7.jpg

Bike 6.jpg

Bike 5.jpg

Bike 2.jpg

Re: brake light wiring

Posted: Sun May 10, 2020 5:46 pm
by Mick D
Hi

Along the inside of the footrest tube, up the frame down tube, through the grommet in the rear mudguard clip to the mudguard and out to the stop light. You'll need to split the loom at the down tube to pick up a power feed.

Thin cable ties will hold the loom on the inside of the footrest tube and will not be obvious.

Regards Mick

Re: brake light wiring

Posted: Sun May 10, 2020 6:15 pm
by JohnnyBeckett
HI Mick inside the footrest tube looks very close to the swinging arm unless i can get very thin 2 core cable and try it but the old 2 core cable that was on the bike was to thick to go behind the foot tube it would be good if i can see some photos of how it is fitted :?: :?